| Workpiece |
| Category |
Automotive parts@-Engine Component |
|
| Name of Workpiece |
Camcap |
| Material |
Aluminum Alloy |
| Description |
@Matching surface
ACross-hole of primary hole of 9mm diameter
and secondary hole of 5mm diameter |
| Pre-Processing@ |
@Milling@ADrilling |
| Processing Methods/Conditions |
| Tool Used |
@A11-CB40M
ACH-A12-5M |
|
| Description |
@After milling, deburr the matching surface
AAfter drilling, cross-hole deburr |
| Conditions |
Tool Revolutions@@1500rpm@A10000rpm |
| Depth of Cut@@0.5mm |
| Feed Rate@ @2000mm/min@A300mm/min |
| Effectiveness on Installation of XEBEC Cutting Fiber/ Cross-Hole Deburring
Tool Alumina Fiber Rod Type |
| Before |
Tool UsedFAbrasive-impregnated nylon brushes |
|
| Process using nylon brushes left excessive burrs; insufficient process
yield required additional processing by hand |
| After |
Tool UsedF@Cutting Fiber@A11-CB40M
@ACross-Hole Deburring Tool Alumina Fiber Rod Type@CH-A12-5M |
|
| No more burrs left; stable and efficient, full automation with marching centers was possible |