| Workpiece |
| Category |
Automotive part-Engine component |
 |
| Name |
Connecting Rod |
| Material |
S45C |
| Description |
Processing area 20mm×15mm |
| Pre-Processing |
Broaching |
| Processing Methods/Conditions |
| Tool Used |
A21-CB25M |
|
| Description |
Removing burrs caused by broach process |
| Conditions |
Tool revolutions 3300rpm |
| Depth of cut 0.4mm |
| Processing time --- |
| Effectiveness on Installation of XEBEC Cutting Fiber |
| Before |
Tool Used：Abrasive-impregnated nylon brushes |
|
| Nylon brushes left burrs; additional process by hand was required. Quality
was unstable. |
| After |
Tool Used：Cutting Fiber A21-CB25M |
|
| No more burrs; full automation of process was possible. |