| Workpiece |
| Category |
Automotive part-Engine component |
 |
| Name |
Plate |
| Material |
SPH |
| Description |
160mm diameter |
| Pre-Processing |
Punch Pressed |
| Processing Methods/Conditions |
| Tool Used |
A21-CB40M |
|
| Description |
External circumference: removing burrs caused by the press. Deburring through
rotating work and tool to right + rotating work and tool to left. |
| Conditions |
Tool revolutions 3000rpm |
| Tool pressure 1.0kgf |
| Processing time 12sec／pc |
| Effectiveness on Installation of XEBEC Cutting Fiber |
| Before |
Tool Used：Abrasive-impregnated nylon brushes |
|
| Nylon brushes with grinding powder did not have enough grinding power,
and abrasive stones did not have a good fit. Excessive burrs remained,
and automation was impossible. |
| After |
Tool Used：Cutting Fiber A11-CB40M |
|
| No more burrs left; full automation of the process was possible. |