| Workpiece | |||
| Category | Automotive parts - Engine |  |
|
| Name | Crank Shaft | ||
| Material | Carbon steel | ||
| Pre-Processing | Drilling (Cross-Hole) Crossing part of pin and journal |
||
| Processing Methods/Conditions | |||
| Tool Used | CH-PM-5R-C01 (XEBEC Cross-Hole Deburring Tool Ceramic Stone Type) |
||
| Description | Machining Center Cross-Hole Deburring of pin and journal (obliquely-crossed) |
||
| Conditions | Revolutions 1500min-1 | ||
| Cutting Depth 0.5mm | |||
| Process Time Approx. 5sec | |||
| Feed Speed N/A | |||
| Effectiveness on Installation of XEBEC Cross-Hole Deburring Tool | |||
| Before | Tool Used：Cutter |  |
|
| Manual deburring left burrs and resulted low process yield | |||
| After | Tool Used：CH-PM-5R-C01 |  |
|
| No burrs left and edge quality stabilized
Achieved full automation with machining center and cost down |
|||