| Workpiece | |||
| Category | Automotive parts - Engine |  |
|
| Name | Cylinder Head | ||
| Material | Aluminum alloy casting | ||
| Pre-Processing | Face milling Cutting with diamond cutter |
||
| Processing Methods/Conditions | |||
| Tool Used | A11-CB100M (XEBEC Cutting Fiber) |
||
| Description | Machining Center Deburring of the matching surface after face milling |
||
| Conditions | Revolutions 1000min-1 | ||
| Cutting Depth 0.2mm | |||
| Process Time Approx. 60sec | |||
| Feed Speed 1200mm/min | |||
| Effectiveness on Installation of XEBEC Cutting Fiber | |||
| Before | Tool Used：Wire brush |  |
|
| Manual processing caused unstable edge quality, high cost | |||
| After | Tool Used：A11-CB100M |  |
|
| Edge quality stabilized, flatness of sealing surface lead to better sealing ability Achieved full automation with machining center and cost down |
|||