| Workpiece | |||
| Category | Automotive parts - Engine |  |
|
| Name | Input Shaft | ||
| Material | Low alloy steel (CrMo) | ||
| Pre-Processing | Drilling (Cross-Hole) | ||
| Processing Methods/Conditions | |||
| Tool Used | CH-A12-5M CH-A12-7M (XEBEC Cross-Hole Deburring Tool Alumina Fiber Rod Type) |
||
| Description | Custom machine Cross-Hole Deburring |
||
| Conditions | Revolutions 10000min-1 | ||
| Cutting Depth N/A | |||
| Process Time Approx. 20sec | |||
| Feed Speed 300mm/min | |||
| Effectiveness on Installation of XEBEC Cross-Hole Deburring Tool | |||
| Before | Tool Used： Impregnated nylon brushes + deburring by hand |
 |
|
| Manual deburring left burrs and resulted low process yield | |||
| After | Tool Used：CH-A12-5M、 CH-A12-7M |  |
|
| No burrs left and edge quality stabilized Achieved full automation with custom machine |
|||