| Workpiece |
| Category |
Automotive part−Fuel system |
 |
| Name |
Injector body |
| Material |
ＳCM |
| Description |
20mm diameter |
| Pre-Processing |
Cutting and boring |
| Processing Methods/Conditions |
| Tool Used |
A11-CB15M |
|
| Description |
Deburring perforated edges and threaded areas |
| Conditions |
Tool revolutions 3000 rpm |
| Tool pressure 0.5 kgf |
| Processing time 1sec/threaded area |
| Effectiveness on Installation of XEBEC Cutting Fiber |
| Before |
Tool Used：Abrasive-impregnated nylon brushes |
 |
| Nylon brushes with grinding powder lacked grinding power and left burrs.
This made additional processes by hand necessary, and caused unstable quality
and increased costs. |
| After |
Tool Used：Cutting Fiber A11-CB15M |
 |
| No more burrs; full automation of the process was possible. |