| Workpiece |
| Category |
Automotive part-Engine component |
 |
| Name |
Rocker Arm |
| Material |
SCr420 |
| Description |
Cutting area approx. 25mm diameter |
| Pre-Processing |
Cutting |
| Processing Methods/Conditions |
| Tool Used |
A21-CB40M |
|
| Description |
Automated deburring on special machine after milling process. |
| Conditions |
Tool revolutions 3000rpm |
| Tool pressure 1.0kgf |
| Processing time 4.8sec／pc |
| Effectiveness on Installation of XEBEC Cutting Fiber |
| Before |
Tool Used：Abrasive-impregnated nylon brushes |
 |
| Process using nylon brushes with grinding powder left excessive burrs; insufficient process yield required additional processing by hand. |
| After |
Tool Used：Cutting Fiber A11-CB40M |
 |
| No more burrs left; full automation of the process was possible. |