| Workpiece |
| Category |
Electric part |
 |
| Name |
Motor part |
| Material |
Electrical Steel |
| Description |
Outer circumference: 40mm |
| Pre-Processing |
Cutting |
| Processing Methods/Conditions |
| Tool Used |
A11-CB25M |
|
| Description |
Rotating workpiece and tool. |
| Conditions |
Tool revolutions 3000rpm |
| Tool pressure 0.5kgf |
| Feed Rate 5mm／sec |
| Effectiveness on Installation of XEBEC Cutting Fiber |
| Before |
Tool Used：Abrasive-impregnated nylon brushes |
 |
| Nylon brushes left burrs and had a short tool life. |
| After |
Tool Used：Cutting Fiber A11-CB25M |
 |
| Burrs were eliminated, finish quality was improved. |