| Workpiece |
| Category |
General Machine Component |
 |
| Name |
Valve Case |
| Material |
FRP (Glass Fiber and Resin) |
| Description |
Cross-hole of Primary hole 5mm dia./ Secondary hole 2mm dia. |
| Pre-Processing |
Molding |
| Processing Method and Conditions |
| Tool Used |
CH-A12-3M |
|
| Description |
After molding, minimize the burr size with a drill and to deburr |
| Conditions |
Tool Revolutions 10000rpm |
|
| Feed Rate 300mm/min |
| Effectiveness on Installation of XEBEC Cross-Hole Deburring Tool |
| Before |
Tool Used：Cutter |
|
| Long manual processing time with a cutter and left scratches on the finishing
surface |
| After |
Tool Used：Cross-Hole Deburring Tool Alumina Fiber Rod Type CH-A12-3M |
|
| Work efficiency improved with automated deburring by a custom machine and
no more burrs left |