Alumina Fiber Rod Type |
Target Bore Diameter
in Primary Processing
|
Brush Diameter
a |
Shaft Diameter
b |
Shank Diameter
c |
Full Length |
Product Code |
¦Õ3.5¡Á5mm |
¦Õ1.5mm |
¦Õ4mm |
¦Õ3mm |
120mm |
CH-A12-1.5M |
- This tool can’t be used for the cross-hole of which bore diameter in primary processing is less than
¦Õ4mm or that is located more than 40mm from the insertion opening of this tool, due to shaft diameter is
¦Õ4mm and brush length is 50mm.
- Operate the tool at around 18,000min-1. (maximum 20,000min-1)
|
