Floating holder for XEBEC Cutting Fiber.
For consistently higher quality, simpler process control, and longer tool life. 		交差穴バリ取りツール　セラミック砥石タイプ　製品写真


Features

Multitasking machine


Drill Press		 ■Features
  • The tool holder floats by the action of the spring inside the holder, thus assuring stable processing through load control.
  • For use with machining centers, NC lathes, drilling presses, special purpose machines, and other machine tools.
  • Vary the cutting load by simply changing the spring for the desired processing quality.
■Performance
  • Delivers stable edge quality by adjusting for changes in cutting amount due to tool wear.
  • Prolongs time to compensate for cutting depth under tool wear and amount of fiber rod projection.
  • Reduces the amount of tool wear to stabilize processing conditions.
 
 
Use
 

Demonstration movie

[Applications for XEBEC Floating Holders mounted on a machine]
Windows Media Player is needed for playing demonstration movie.
■How to Mount Special Bushing
Align the shank-fastening screw hole with setting mark,
insert the special bushing as far as it will go, then secure the shank-fastening screw.
 
■Replacement of Inner Spring
  1. Remove the steel ball cap screws retaining the steel balls, and then remove the washers and steel balls inside the main unit. (2 locations)
  2. Remove the tool holding portion from the main unit, replace the spring, apply a thin coating of grease on sliding portion (tool holding portion), and then return it to the main unit.
    When returning the tool holding portion to the main unit, check that there is no dirt, etc.
    adhering to the tool holding portion or within the boat-shaped groove.
    Also check for dirt, etc. within the tool main unit.
    When returning it, align the boat-shaped groove of the tool holding portion with the hole in the cap screw retaining the steel ball, which is on the main unit of the floating holder.
    *Recommended grease ：Multi-Purpose Lithium Grease（NLGI #２）
  3. Insert steel balls and washers then and firmly secure the cap screw for retaining the steel balls. Use only XEBEC-specified cap screws for steel balls, as well as Xebec-specified washers and steel balls.
  4. After replacing the springs, press the bottom of  the tool holding portion with your fingers, and check to see that tool holding portion slides 6 mm.
    ※ Use springs specified by XEBEC (refer to “inside spring specification”) or it may result in malfunction or breakage of the tool.