XEBEC Back Burr Cutter and Path™ Process Conditions

Standard processing conditions: Regular type

 

Product
Code


Cutter
Diameter
φDc
Projection Amount Feed per rev


Spindle Speed

Table Feed
(mm)   (mm/rev) (min-1) (mm/min) 
XC-08-A 0.8 5Dc 0.03 43000 1300
XC-13-A 1.3 5Dc 0.03 27000 800
XC-18-A 1.8 5Dc 0.03 19500 580
XC-28-A 2.8 5Dc 0.08 12500 1000
XC-38-A 3.8 5Dc 0.13 9200 1200
XC-48-A 4.8 5Dc 0.15 7200 1100
XC-58-A 5.8 5Dc 0.15 6000 900

Standart processing conditions: Straight type

Product
Code
Cutter
Diameter
φDc
Projection
Amount
Feed per rev Spindle Speed Table Feed
  (mm)   (mm/rev) (min-1) (mm/min)
XC-18-B 1.8 10Dc 0.05 4400 220
XC-28-B 2.8 10Dc 0.08 2800 220
XC-38-B 3.8 10Dc 0.08 2000 160
XC-48-B 4.8 10Dc 0.08 1600 120
XC-58-B 5.8 10Dc 0.08 1300 100

1. When processing alumnium alloy, you can increase the spindle speed about twice the speed listed on the table above.

2. In order to improve processing result, change the spindle speed, table feed or deburring amount.

3. If the spindle speed and /or table feed fail to meet the standard conditions listed in the table, or an abnormal vibration or noise occurs, lower the spindle speed and table feed at an equel rate. Make sure to maintain the feed per rev (fn).

page top