XEBEC Self-Adjusting Sleeve must be mounted on an equipment which enables to stop and hold the sleeve at the fixed position.
Predetermined length can be adjusted between 0.05mm to 1mm in 0.5mm increments in a single action.
How to Use
How to set XEBEC Self-Adjusting Sleeve
<Example> If the sleeve main body travels in Y-direction of the rack gear
With the main spindle at its normal orientation angle, mount the sleeve on the main spindle so that the side gear of the sleeve is directed towards the rack gear. Then, check that the datum plane of the sleeve is parallel to the Y-axis.
Ensure to adjust the “Tilt a” below 0.25mm.
How to mount the rack gear
Mount the rack gear away from interferers (jigs, etc.) and in a position where an operating area (tool interfering area) can be ensured as shown in below figure.
Securely fasten the hexagonal brace with the torque 40N/m on the slide table. Also, securely fasten the rack gear to the hexagonal brace with the torque 15N/m using a wrench. Otherwise, there is a risk of damaging the main body and/or the machine when the sleeve passes through the rack gear.
How to decide projection adjustment cycle
1. Figure out the amount of brush wear by a process quantity or travel length.
2. Set and execute the macro program so that the projection amount is adjusted at the given intervals.
Use process quantity; a cycle time is more important
Deburring an aluminum part
Travel length: 200mm per workpiece
Brush wear: 2μm per workpiece
Brush wear: 0.2mm per 100 workpieces (Total ravel length 20,000mm）
Set the cycle to every 100 workpiece (0.2mm brush wear)
Use travel length; processing quality is more important
Finish processing of a cast-iron part's edges
Travel length: 1500mm per workpiece
Brush wear 50μm (0.05mm) per workpiece
Set the cycle to every 1500mm (50μm brush wear)